MoldFlow: No Changes

May 02, 2008

MoldFlow: No Changes

Buzz Kross writes:

I heard you were wondering if we intended to continue the link to competitive tools. Absolutely.
We plan no changes. Moldflow is a key aspect of our CIM strategy. We intend to keep the solution open and will continue to work with everyone. Earlier today, I sent a e-mail to virtually all my competitors telling them that this is our plan.

Posted at 05:56 PM in Mergers & Acquisitions | Permalink

Comments

That would be all except SolidWorks :-)

I really miss not having MoldflowXpress in SW 2008....

Posted by: Kevin Quigley | May 03, 2008 at 04:01 PM

Verify your Comment

Previewing your Comment

Posted by: |

This is only a preview. Your comment has not yet been posted.

Your comment could not be posted. Error type:

Your comment has been saved. Comments are moderated and will not appear until approved by the author. Post another comment

The letters and numbers you entered did not match the image. Please try again.

As a final step before posting your comment, enter the letters and numbers you see in the image below. This prevents automated programs from posting comments.

Having trouble reading this image? View an alternate.

Post a comment

Comments are moderated, and will not appear until the author has approved them.

Your Information

(Name is required. Email address will not be displayed with the comment.)

Name is required to post a comment

Please enter a valid email address

Invalid URL

WorldCAD Access

talking about computers and design by Ralph Grabowski

May 02, 2008